Problems, Questions, & Comments? / Contact / Forum / Copyright(c) 2006-2025 by the Im Lab
Start with a power cycle, check your SP settings, and if all else fails, contact your local Ricoh service provider for a board inspection. on how to safely enter for your specific Ricoh model?
The specific Service Provider (SP) setting for the Cheetah (Smart) panel might be incorrectly set to "Not Connected". Voltage Fluctuations: sc673-10 ricoh error
Check the USB cable and the power harness located behind the operation panel. Start with a power cycle, check your SP
The SC673-10 error occurs when the Controller Board sends a startup signal to the Operation Panel, but . The -10 sub-code typically indicates that the failure happened during the initial boot sequence before the panel’s operating system fully loads. Voltage Fluctuations: Check the USB cable and the
In rarer cases, a faulty HDD or optional interface board can interfere with the boot sequence. Recommended Troubleshooting Steps
The main controller (CATS module) does not see the required response from the operation panel.